How To Iron Fabric For Quilting – A Step By Step Guideline

As a new quilter, you may be confused about “How To Iron Fabric For Quilting”. To create a nice quilt pattern and an attractive look, iron fabric for quilting is an essential step. So, in this process, what should you start with? This post will share a step-by-step guideline to help you get a perfect quilting fabric ironed.

How To Iron Fabric For Quilting

Step 1: Pre-wash The Fabric

Our advice for the first step is pre-washing the fabric. In fact, quilting fabric is coated with starch, chemicals, which give it a crisp look.

In the manufacturing process of fabric, threads are stretched on a loom. It results in pulling fiber into an unnaturally straight position. Coating processing is another step to keep it stable and taut. So, pre-washing is likely a way to make coated threads relax and return to their right position. Pre-washing would act as a protector to prevent shrinkage later on.

Additionally, if your fabric quilting is covered by formaldehyde, pre-washing the fabric is the must-do step to protect your respiratory system.

You should wash the fabric in cool water with a small amount of bleach-free detergent. It will be dried at low heat temperature and removed from the dryer as soon as it is dry.

Pre-washing isn’t a must-step before ironing for quilting. Dyes could be lost in the first wash, especially with red, purple, and some vivid color. Bleeding dyes can stain other sections of fabric in the pre-wash or transfer dyes onto patches in a finished quilt. So normally, you should test bleeding first or use spray starch instead of pre-washing to avoid bleeding dyes.

Step 2: Test The Iron For Heat

After selecting the right setting for your best quilting iron, you’d better check the proper heat temperature. If it leaves marks after ironing, you should adjust the lower temperature. Continue checking until you get the best temperature.

Step 3: Using Steam

Steam particularly works for deep wrinkles and thick seam allowances. If you want to press the open seams, using steam is extremely useful. You can use a steam function available in steam irons or a spray bottle. Remember that you will only use clean water to soften the fabric. Using a water-containing fabric softener or scented water might make the fabric stain.

Spray a little water and wait a few seconds for the fabric to soften, then use the point of the iron to go along the seam line and press it flat. Most of the time, you should press the wrong side of the fabric for its color-protecting.

Step 4: Flip The Fabric Over

Flipping the fabric over is a good way to protect your fabric from being burned. So, don’t forget!

Step 5: Press From The Back With A Hot Dry Iron

Layout the fabric on the iron board or on the flat surface and press seams from the back. There are five types of pressing the seams as below:

Press the straight seam

Press along the edge of grain fabric and move the tip of iron from the lighter color piece to the darker ones. It helps eliminate puckers into the fabric.

Press the bias seam

Press the iron under a 45-degree angle to the seam and along the grain fabric to minimize distortion.

Press opposite seam

If you are pressing many blocks made up of adjoining rows, let’s press seams in the opposite directions. In the odd rows, press the seam from the right over the left. Then, in the even row, you press the seam from leftover to the right.

Finger pressing

Start from the wrong side, press your finger along the seam allowances. Then, turn to the right side and press again along with them. Finger pressing is a good way to test which way seams need to be pressed.

Press seam open

You will also start from the wrong side then use your finger to open the seam ahead of the iron moving.

Conclusion

Through the five steps as above, we believe that the question ‘How To Iron Fabric For Quilting’’ will no longer bother you. You are confident of getting a perfect quilting fabric ironed. If you have any better experiences, please share them with us.

Thank you for reading!

You May Also Like…